Removing Wall to Wall Carpeting by Bob Villa | Katonah Homes

Source: charlesandhudson.com

Source: charlesandhudson.com

I am moving to a new house where the living room and dining area have wall-to-wall carpeting. I asked the previous owner, and he told me there is hardwood flooring underneath. Could you please tell me how to remove carpet?

Even with regular vacuuming, carpeting accumulates a great deal of dust, dirt and debris. So if and when you finally decide to rip it up, be sure to give the floor covering one last good vacuuming. Empty the room of furnishings, open the windows and don your dust mask — then get to work!

Materials & tools

  • Large contractor trash bags
  • Nail puller pliers
  • Steel putty knife
  • Flat pry bar (at least 15 inches)
  • Hammer
  • Utility knife (or tin snips)
  • Leather work gloves
  • Carpet padding adhesive remover (optional)
  • Scraper (optional)

Step 1

Was your carpeting installed under shoe molding? Assuming it was, the first thing to do is remove that trimwork with your putty knife and pry bar. Check the molding for damage: If it remains in good shape, save it for reuse. Chances are the trim is full of nails; when pulling them out, take care not to inflict any avoidable damage. If the molding looks a little worse for wear, consider giving it a fresh coat of paint prior to re-installation.

Step 2

Now that there is no obstruction between you and the carpeting, use a utility knife or a sharpened pair of tin snips to cut the material into three- or four-foot-wide strips. (Cut all the way through the backing but stop short of the flooring beneath.) Once complete, begin pulling the carpet away from the tack strips on the perimeter. Roll up the sections as you remove them, placing them into heavy-duty trash bags ready for disposal.

 

read more…

 

http://www.zillow.com/blog/remove-wall-to-wall-carpeting-160890/

 

Leave a Reply

Your email address will not be published. Required fields are marked *